Contact us

Power plants that use a steam turbine to produce electricity are categorized according to the source and use of the steam. Nuclear, coal, combined cycle, cogeneration, and some solar power plants use steam cycles in order to produce power.

10/25/2018 · Cogeneration / Combined heat and Power (CHP) Cogeneration (cogen) through combined heat and power (CHP) is the simultaneous production of electricity with the recovery and utilisation heat. Cogeneration is a highly efficient form of energy co

The most common type of combined cycle power plant utilizes gas turbines and is called a combined cycle gas turbine (CCGT) plant. Because gas turbines have low efficiency in simple cycle operation, the output produced by the steam turbine accounts for abo

The quantity of NOx emissions generated by a combined gas turbine-steam boiler power plant is controlled by recycling a controlled amount of the steam boiler exhaust gas to the air compressor of the gas turbine such that the recycled gases constitutes up

Rotor Air Cooler / Kettle Boiler HX. Our Shell & Tube Rotor Air Cooler Kettle Boiler Heat Exchangers are used to cool gas turbine rotor cooling air in a Combined Cycle Power Plants. The rotor air heat is tranferred to the water on the shell side, which is

The turbine is connected to a generator and the generator creates the electricity. Though the boiler itself doesn’t generate the power, boilers are nevertheless a fundamental, indispensable part of the power generation process. So in the power plant, the

The steam turbine power plants have an efficiency of about 30% to 35% compared with CCPPs, which have an efficiency from 47% to 58%. Newer gas turbine technology will make combined cycle efficiencies to range between 60% and 65%.

7/25/2018 · In a typical Combined heat and power plant system there is a steam or gas turbine which take steam and drives an alternator. A waste heat exchanger is also installed in cogeneration plant, which recovers the excess heat or exhaust gas from the

6/1/2014 · A Combined Cycle Gas Turbine (CCGT) integrates two cycles- Brayton cycle (Gas Turbine) and Rankine cycle (Steam Turbine) with the objective of increasing overall plant efficiency. This is accomplished by utilising the exhaust of Gas Turbine thr

Combined Cycle Gas And Steam Turbine Power Plants by Rolf Kehlhofer. Combining two or more thermal cycles within a single power plant. In all cases, the intention was to increase efficiency over that of single cycles. Thermal processes can be combined in

power generation was carried out to improve the performance of the thermal power plant. A thermodynamic analysis of the combined cycle through a typical pattern was done. Appropriate assumptions were made for two kinds of combined cycles, simple gas turbi